DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase

You looking to find the "DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase" Good news! You can purchase DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

Price: $3,859.99    

Product Feature

• Center-mounted fence safely encloses the rear of the cutterhead when working to the front of the machine
• Rack and pinion movement for smooth, precise adjustment.
• Infeed and outfeed tables have an easy-to-use lever for raising and lowering table bed
• Parallelogram support system allows the table to move up or down in the same arc as the cutterhead
• Hinged door and removable door panel allow for easy access to the motor and V-belts

Product Description

The DELTA 37-361 12-inch, 3 HP Jointer features a center-mounted fence which safely encloses the rear of the cutterhead when working in front of the machine for maximum safety. The rack and pinion design ensures smooth operation and the parallelogram support system allows the table to move with the cutterhead which produces more efficient cutting, less tear-out, and safer operation. The three HP, single-phase motor powers the three-knife cutterhead configuration at speeds of 3,450 RPM, which produces a cutterhead speed of 15,000 CPM. The long 84-inch table makes it easy to handle large workpieces.

DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase Review

first off, I have to say that the notion of getting the widest jointer you can afford is absolutely correct. I had a 6" Delta for several years, and was always an inch or two shy of being able to easily flatten the typical board. Now - no problem - its rare that you run across anything more than 10" wide.I've had this jointer (single phase motor) for a couple of years now. After considering several brands in and around this size, including the new line of Grizzly, General International, and a Brazilian brand that made jointers for Delta (I believe Invicta), even with the added cost I decided to get Delta because . . . well, its Delta. They've been very good anytime I've had a problem with one of their machines.So, this machine is very solid, and does its job well. But - the blades are relatively difficult to change, particularly when compared with other brands. You can't get it with a Tersa cutter. The dust collection is poor; for fine cuts its constantly clogging right below the cutter hed. The lever action height adjustment is more difficult to fine adjust than a wheel. On the up side, the cast iron came in flat to a couple thousandths, and had pretty much stayed that way (cast iron continues to shrink for a couple of years after its been cast and machined - inexpensive cast iron needs to be continuously adjusted, and occasionally remachined).So, if for a lot of money you are OK with a very solid jointer, this works fine (even if made in Tawain). But in retrospect, I'd take a much closer look at the other brands that offer more features and have improved their service. Help other customers find the most helpful reviews� Was this review helpful to you?�Yes No Report abuse | PermalinkComment Comment

Most of the consumer Reviews tell that the "DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase" are high quality item. You can read each testimony from consumers to find out cons and pros from DELTA 37-361 12-Inch 3 Horsepower 230-Volt Jointer, 1 Phase ...